ESP boards are a low cost Wi-Fi chips that have built in flash chips allowing you to build a single chip device capable of connecting to Wi-Fi. newer versions like the ESP32 boards also provide you BLE (Bluetooth low energy) and there’s loads of variety of boards you can use.
-
D1 Mini V2 NodeMcu 4M Bytes Lua WIFI Internet Of Things Development Board Based ESP8266
- ₹259.00 (inc. GST)
- Microcontroller: ESP-8266EX Operating Voltage: 3.3V Analog Input Pin voltage: 3.2V max On-Board Power Supply Switch Output: 5V Board Size: 34.2mm x 25.6mm Weight: 10-15g
- Add to cart
-
- Out of StockSale!
DSO138 2.4″ TFT Handheld Pocket-size Digital Oscilloscope Kit DIY Parts Electronic Learning Set Soldered
- ₹1839.00 (inc. GST)
- This kit uses ARM Cortex-M3 processor (STM32F103C8), and includes a 2.4-inch color TFT display screen. Adjustable vertical displacement, and with instructions. With automatic, regular and one-shot modes, easy to capture the moment waveform. Available rising or falling edge trigger. Observable previous trigger waveform (negative delay). Can freeze at any time waveform display (the HOLD function). Maximum Real-time Sampling Rate: 1Msps…
- Read more
-
-
ESP-12E: ESP8266 Serial Port WIFI Wireless Transceiver Module For Arduino
- ₹149.00 (inc. GST)
- WS2812 Led on board. 802.11 b/g/n Wi-Fi Direct (P2P), soft-AP Integrated TCP/IP protocol stack Integrated TR switch, balun, LNA, power amplifier and matching network Integrated PLL, regulators, DCXO and power management units
- Add to cart
-
- Sale!
LoRa Ra02 SX1278 Module 433MHZ Wireless Spread Spectrum Transmission
- ₹449.00 (inc. GST)
- Communication distance: 15KM Sensitivity: down to -148dBm Programmable bit rates: up to 300kbps RSSI dynamic range: 127dB Wireless frequency: 433MHz Working voltage: 1.8-3.7v Working temperature: -40-+80 ℃
- Add to cart
-
- Out of Stock
PICkit3 Debugger Programmer Emulator Controller Development Board
- ₹1369.00 (inc. GST)
- Full-speed USB support using Windows standard drivers Real-time execution Processors run at maximum speeds Built-in over-voltage/short circuit monitor Low voltage to 5V (1.8-5V range) Diagnostic LEDs (power, active, status) Read/write program and data memory of microcontroller Erase of all memory types (EEPROM, ID, configuration and program) with verification Peripheral freeze at breakpoint
- Read more
-
-
- Sale!
NodeMCU Baseboard ESP8266 Serial Port Baseboard Lua WIFI Development Board
- ₹184.00 (inc. GST)
- The perfect solution for breaking out the pins from Lua V3 Nodemcu. Small and Handy module. The spacing between mounting headers is 25.5 mm.. Lead-out all the IO ports of the ESP-12E development board Lead out the pins of 5V and 3.3V power supply Convenient to connect with peripheral modules Onboard 5V / 1A DC-DC step-down converter circuit Onboard power…
- Add to cart
-
- Sale!
WeMos D1 R2 WiFi ESP8266 Development Board
- ₹319.00 (inc. GST)
- Microcontroller ESP8266 Digital I/O Pins 11 Analog I/O Pins 1 Operating Voltage 3.3 Flash Memory 4 MB
- Add to cart
-
ST-Link V2 Mini STM8 STM32 Simulator Download Programmer
- ₹389.00 (inc. GST)
- PCB installed inside of aluminum alloy U disk shell, portable, safe and reliable! Interface definition directly marked on the shell, clear, convenient and practical! 5V, 3.3V offers at the same time, allowing you to program your target board with both 5V and 3.3V Shell characters using laser engraving, never fade off! Permanent clarity! 500MA internal resettable fuse, complete protection of your expensive computer motherboard!…
- Add to cart
-
- Out of Stock
USB Logic Analyze 24M 8CH, MCU ARM FPGA DSP Debug Tool
- ₹689.00 (inc. GST)
- Logical light indication: a small light indicate CHO electrical level. Input feature: 5PF,100K Ohm. USB power supply; USB logic analyzer for monitoring, analyzing and debugging digital circuits 8-Channels USB logic analyzer with a 24Mhz sampling frequency Can analyze UART, IIC, and SPI, etc automatically Great for MCU, ARM system and FPGA development Voltage: 0-5.5V
- Read more
-
-
ESP-12F ESP8266 Wifi Wireless IoT Board Module
- ₹139.00 (inc. GST)
- Communication interface voltage: 3.3V Working current: 240mA(MAX) Serial port baud rate: 115200 (default), can be modified to other values by AT command Serial communication format: 8N1 Wireless Network Mode: station / softAP / SoftAP + station Wireless criteria: 802.11 b / g / n WIFI @ 2.4 GHz, support for WPA / WPA2 security mode +19.5dBm output power
- Add to cart
-
ESP8266 Adapter Plate Serial Wireless WIFI Module
- ₹35.00 (inc. GST)
- It features reserved land-pattern for the 3.3V regulator It has Pinouts on the top layer in black color. Compatible with Latest ESP-12F ESP8266 Wifi Module It includes a 10K pull-up resistor populated on PCB.
- Add to cart
-
Espressif ESP32-WROOM-32 4M 32Mbit Flash WiFi Bluetooth Module
- ₹339.00 (inc. GST)
- ESP32-D0WD core Supports multiple external QSPI flash and SRAM chips 32Mbits 3.3V SPI flash 802.11 b/g/n (802.11n up to 150Mbps) Wi-Fi protocol Bluetooth v4.2 BR/EDR and BLE SD card, UART, SPI, SDIO, I2C, LED PWM, Motor PWM, I2S, and IR module interfaces Hall sensor
- Add to cart